Filter
Top Products
24
TROUBLE SHOOTING TABLE
If unit does not turn on - LED does not illuminate:
• Depress main power button on the riescope rst, and then the infrared remote switch.
• Check and if necessary, replace battery.
• Check battery within the infrared remote switch, and if necessary, replace its’ battery.
If unit powers down (display goes blank when attempting to power the laser):
• e battery is either weak or low quality. Replace the battery with a good quality lithium battery.
• e last range reading does not need to be cleared before ranging another target. Simply aim at the
new target using the reticle, depress the power button and hold until new range reading is displayed.
If target range cannot be obtained:
• Make sure LED is illuminated.
• Make sure that the power button is being depressed
• Make sure that nothing, such as your hand or nger, is blocking the objective lenses (lenses closest to
the target) that emit and receive the laser pulses.
• Make sure unit is held steady while depressing power button.
Specifications, instructions, and the operation of these products are subject to change without notice.
FDA SAFETY
Class 1 laser product in accordance with IEC 60825-1:2007.
Complies with 21 CFR 1040.10 and 1040.11 for laser products except for deviations pursuant to Laser
Notice No. 50, dated June 24, 2007.
Caution: There are no user controls, adjustments or procedures. Performance of procedures other than those specified herein may result in access to
invisible laser light.