Filter
Top Products
14
ELEVATION AND WINDAGE ADJUSTMENT
Your Bushnell
®
YARDAGE PRO
®
LASER RANGEFINDER RIFLESCOPE features finger-adjustable,
audible-click elevation and windage adjustments. If the point of impact of the bullet deviates from the
aiming point, then adjustment of the windage and elevation must be made.
To adjust windage, remove the threaded cap from the Windage Adjustment (Figure 1.7).
Grasp the knob and turn it in the appropriate “L” (Left) and/or “R” (Right) direction indicated by the
arrows. Each “click” or increment on the adjustment scale ring will change the bullet impact by 1/4”
Minute of Angle. 1/4 MOA corresponds to 1/4 inch at 100 yards, 1/2 inch at 200 yards, 3/4 inch at
300 yards and so on.
RESETTING THE ADJUSTMENT SCALE RING
This step is not necessary, but, for future reference, you may want to realign the zero marks on the
Adjustment Scale Rings with the index dots.
- Using a coin, remove the center screw from the windage or elevation control. Lift the turret up being
careful not to rotate it.
- Position the turret to zero, or where you would like it to be.
- Replace and tighten the center screw, making sure you do not rotate the turret.