Filter
Top Products
Chapter 2
Getting
Started
This chapter can help you to get started using the Helm Weigh Scale
module. The procedures included here assume that you have a basic
understanding of PLC products. You should understand electronic
process control and be able to interpret the ladder logic instructions
required to generate the electronic signals that control your application.
Because it is a start-up guide, this chapter does not contain detailed
explanations about the procedures listed. It does, however, reference
other chapters in this book where you can get more information about
applying the procedures described in each step. It also references other
SLC documentation that may be helpful if you are unfamiliar with
programming techniques or system installation requirements.
If you have any questions or are unfamiliar with the terms used or
concepts presented in the procedural steps, always read the referenced
chapters and other recommended documentation before trying to apply
the information.
This chapter will:
• Tell you what equipment you need
• Explain how to install and wire the module
• Show you how to set channels for the sensor input
Required Tools and Equipment
Have the following tools and equipment ready:
• Small blade screwdriver
• Appropriate strain gage cable
• Programming equipment (All programming examples shown in this
manual demonstrate the use of Allen-Bradley’s RS Logix 500.
Page 2-1