Filter
Top Products
8
4. Place sight pin, thread down, through top of front
sight. Attach circular nut.
Rear Sight for RX150
The RX150 is equipped with an adjustable
rear sight (Unless bow is shipped in a
package or kit.) preinstalled at the factory.
See Figure 1
Installing Optional Scope
If you choose to use a scope, you must remove the elevation screw.
To do this, remove the scope mount. Remove the elevation screw
from bottom side of the scope mount. Reinstall the scope mount.
With the elevation screw removed the scope will slide onto the
scope mount.
Sighting in the RX150
Tip: Adjust rear blade sight in the direction of the error.
Lower the Blade lower the hit.
Higher the Blade higher the hit.
Move Blade to the right it will hit to the right.
Move Blade to the left it will hit to the left.
Arrow Selection and Proper Flight
Due to the unique design of your Barnett crossbow, it is
imperative that only specified arrows are used. These arrows are
correctly weighted to absorb the high energy generated by the
compound design. Lighter arrows simulate a “dryfire” condition
and will result in damage to the crossbow VOIDING the warranty.
Barnett’s 16” 2117 or 2216 Aluminum arrows are correctly
“spined”.
Stringing the crossbow
Important Do not attempt to string your crossbow by exerting downward
pressure on the stock or prod! This may cause breakage and will void your
warranty. Use only the cable stringer method. Make sure the nockends are
firmly seated on prod
.
1. Place loops of the black steel cable stringer over the prod nockends,
just as you would with a bowstring.
Fig. 1