Filter
Top Products
7
ASSEMBLY GUIDE
RX150
Installing Prod Assembly
Note: During prod assembly procedures, pay close attention to
proper installation of pressure plate and rubber pad. Improper
installation of these items will result in damage and void the
warranty.
1. With 3mm hex key, back out nose bolt until it is flush
with plastic.
2. Install pressure plate with metal surface facing forward
so only the rubber contacts prod.
3. Slide in prod until arrow appears in inspection hole.
The 3/16” hex wrench provided.
4. Once all these steps are completed, tighten up nose bolt
securely with hex key.
Attaching the Foot Stirrup Assembly
1. Remove the two front screws and loosen the back
screws that hold the plates on the front sides of the gun
body.
2. Line up holes in foot stirrup over front hexagon stud.
Make sure foot stirrup is laying in the plastic grooves in
the nose housing.
3. Vertically slide front sight over nose housing and into
grooves.
4. Replace side plates. Make sure screws are tightened
firmly.
An incorrectly installed foot stirrup can cause serious bodily
injury.
Mounting the Front Sight for RX150
1. Remove front sight assembly from hardware package.
2. Place front sight into slots provided with the angle of
front sight pointing towards the trigger.
3. Attach front sight with screws provided through holes
in plate of nose unit. Tighten.