Filter
Top Products
7
8
PREPARING FOR OPERATION
Daytime Sniper Scope:
• Install the battery for illuminated reticle into its housing.
• Adjust the magnification by rotating of magnification ring near eyepiece.
• Observe the scene and adjust the eyepiece for optimal clarity. Bring into focus by rotat-
ing the focusing ring of the eyepiece.
• Turn on the reticle illumination if you need.
• Adjust the reticle brightness by rotating of the 10-position rheostat.
Night Vision Weapon Sight:
• Install the batteries in the seats of the night-vision eyepiece and IR illuminator by the
polarity marks on the devices bodies.
• Turn on the night-vision eye-piece by means of the switch located on its body.
• Observe the scene and adjust the eyepiece for optimal clarity. Bring into focus by rotat-
ing the focusing ring of the eyepiece.
• Turn on the IR illuminator .
• Adjust IR brightness.
• Focus the illuminator by rotating its lens..
BATTERIES
The batteries (included with the unit) are coin style 3 volt lithium batteries (CR2032) for
Electronic Reticle and two 3 volt lithium batteries (CR123A) for Night Vision Eyepiece and
IR Illuminator.
VERY IMPORTANT!
Your Day/Night System comes with a patented technology that puts the lit reticle
of the riflescope into an infrared mode which helps prevent tube burn. However,
even in this mode if the brightness of the reticle is turned up too high you can run
the risk of burning the reticle pattern into your night vision light intensifier tube.
This damage is not covered by the warranty!
When setting the reticle brightness of your scope in the Night Vision Mode
please set the brightness at the lowest visible setting that you are comfortable.
This will prolong the life of the Light Intensifier Tube. We suggest turning the
reticle brightness to the (1) selection then slowly increase it until you clearly see
the reticle. Do not overly increase the reticle brightness.