Filter
Top Products
5
6
THE IR ILLUMINATOR
Infra-red (IR) Illuminators are common for night vision technology. The IR light greatly
enhances the performance of your day/night system (in night mode), while remaining
almost totally invisible to the naked eye. In a dark environment, power up the day/night
system (in night mode) and observe a scene with the IR off. Then observe the same
scene with the IR on. Note the difference in illumination. It is important to remember that
the IR illuminator is simply an infra red light source, and like any light source it may loose
its effectiveness over a great distance.
To fix the IR Illuminator to the riflescope screw the fixation screw on the IR into the thread
on the night-vision eyepiece body.
The IR illuminator control buttons are located on its side.
To switch the Digital IR illuminator on/off press “+” and “-” buttons simultaneously. When
the IR illuminator is switched on you can see the green LED lit.
By pushing the buttons “+” and “-” you may adjust the IR brightness.
The IR beam is focusable to change the field of coverage. To change the beam width
slightly turn the IR lens.
You may notice that beam of IR illuminator might not shine directly in the middle of your
viewing image. You can change the direction of the IR beam slightly in horizontal and
vertical directions with rotation of small screws on the side of IR.
You can also change the position of the IR control
panel fitting your needs. Undoing the small set screw
on back of IR. Then use the included wrench to loosen
back ring, Move the IR to its desired position/angle,
retighten ring with wrench then retighten set screw.
IR Brightness
Adjustment
Battery
Housing
IR Focusing
Fixation
Screw
IR Beam Direction
Vertical Adjustment
IR Beam Direction
Horizontal Adjustment
Battery
Cap