Chapter 41 VRRP
XGS4700-48F User’s Guide
372
Note: Routing domains with the same VLAN ID are not displayed in the table
indicated.
Figure 198 IP Application > VRRP Configuration > IP Interface
The following table describes the labels in this screen.
Table 135 IP Application > VRRP Configuration > IP Interface
LABEL DESCRIPTION
Index This field displays the index number of an entry.
Network This field displays the IP address and number of subnet mask bit of an IP
domain.
Authenticati
on
Select None to disable authentication. This is the default setting.
Select Simple to use a simple password to authenticate VRRP packet
exchanges on this interface.
Key When you select Simple in the Authentication field, enter a password
key (up to eight printable ASCII character long) in this field.
Apply Click Apply to save your changes to the Switch’s run-time memory. The
Switch loses these changes if it is turned off or loses power, so use the
Save link on the top navigation panel to save your changes to the non-
volatile memory when you are done configuring.
Cancel Click Cancel to discard all changes made in this table.
