IES-5106M / IES-5112M / IES-6000M User’s Guide
67
CHAPTER 4
Maintenance
This chapter describes how to perform maintenance on the system hardware.
4.1 Fan Maintenance
This section describes how to change a fan fuse or a fan module on the IES.
4.1.1 Procedure to Remove and Install the IES-5106M/IES-
5112M Fan Module
The IES main chassis has a hot-swappable fan module. The fan module is at the
left on the front panel. Replace the entire fan module if the fuse is not the
problem. Return any malfunctioning fan modules to the manufacturer.
Perform the following procedure to remove the fan module in order to clean the
fan filter or change a fan fuse or the fan module.
1 Loosen the thumbscrews on the front of the fan module.
2 Slide out the fan module.
3 Replace the fuse if it is burnt out (see Chapter 5 on page 75 for fuse information).
If the fuse is not the problem, use a different fan module from the manufacturer.
4 Slide out the fan filter. Clean or replace the filter.
5 Slide the fan filter back into the fan module.
6 Slide the fan module back into the fan module slot.
7 Tighten the thumbscrews.
