A SERVICE OF

logo

Chapter 2 Hardware Installation and Connections
IES-5106M / IES-5112M / IES-6000M User’s Guide
29
2.3.2 Removing MSC and Line Cards
Use the following procedure to remove management switch cards and line cards
from the main chassis.
1 Disconnect all cables from the card.
2 Loosen the two thumbscrews.
3 Pull the two ejector levers firmly until the front of the card is clear of the main
chassis. Pull the ejector levers until they are perpendicular to the front panel.
Note: The MSC has more connector pins than the other cards so when removing it
you need to exert more force to get the front of the MSC clear of the main
chassis.
4 Grasp the center of the front panel of the card with one hand and place the other
hand under the card to support it.
5 Slide the card out of the slot.
Figure 21 Loosening Card Thumbscrews