IES-1000 User’s Guide
6-10 G.SHDSL Commands
<tx vci> =
The VCI setting for the G.SHDSL ports for use with a TX based
network.
<rx vpi> =
The VPI setting for the G.SHDSL ports for use with Rx based
networks.
<rx vpi> =
The VCI setting for the G.SHDSL ports for use with Rx based
networks.
The <rx vpi> and <rx vci> settings will be equal to those of <tx vpi> and <tx vci> if the rx
settings are not configured.
The set pvcs command allows you to configure a single PVC for all of the G.SHDSL ports at once.
6.6.19 Show PVC Command
Syntax:
192.168.1.1 gshdsl> show pvc <port #>
where
<port #> =
A port number, from 1 to 8.
This command allows you to display the PVC parameters of an individual G.SHDSL port
6.6.20 Show PVCs Command
Syntax:
192.168.1.1 gshdsl> show pvcs
This command allows you to display the PVC parameters of all G.SHDSL ports.
6.6.21 Display All G.SHDSL Line Information
Syntax:
192.168.1.1 gshdsl> monitor [<start port> [<stop port>]]
where
<start port> =
The first port number in a range of ports for which you want to display
line information. 1 is used if you leave this blank.
<stop port> =
The last port number in a range of ports for which you want to display
line information. 8 is used if you leave this blank.
This command displays all G.SHDSL line information. Information is updated every five seconds. Press any
key and then press [ENTER] to stop updating information. Use monitor without any port numbers to display
line information for every port.
6.6.22 Set Central Side Port Bonding Command
Syntax:
