Chapter 23 Multicast
GS1920 Series User’s Guide
172
Figure 125 Advanced Application > Multicast > Multicast Setup > MVR > Group Configuration
The following table describes the labels in this screen.
Table 72 Advanced Application > Multicast > Multicast Setting > MVR > Group Configuration
LABEL DESCRIPTION
Multicast VLAN ID Select a multicast VLAN ID (that you configured in the MVR screen) from the drop-down
list box.
Group Name Enter a descriptive name for identification purposes.
Start Address Enter the starting IP multicast address of the multicast group in dotted decimal notation.
Refer to Section on page 161 for more information on IP multicast addresses.
End Address Enter the ending IP multicast address of the multicast group in dotted decimal notation.
Enter the same IP address as the Start Address field if you want to configure only one IP
address for a multicast group.
Refer to Section on page 161 for more information on IP multicast addresses.
Add Click this to create a new entry.
This saves your changes to the Switch’s run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel
to save your changes to the non-volatile memory when you are done configuring.
Cancel Click Cancel to begin configuring this screen afresh.
MVLAN This field displays the multicast VLAN ID.
Group Name This field displays the descriptive name for this setting.
Start Address This field displays the starting IP address of the multicast group.
End Address This field displays the ending IP address of the multicast group.
Delete Select the entry(ies) that you want to remove in the Delete column, then click the
Delete button to remove the selected entry(ies) from the table.
If you delete a multicast VLAN, all multicast groups in this VLAN will also be removed.
Cancel Select Cancel to clear the checkbox(es) in the table.
