Chapter 13 Spanning Tree Protocol
GS1920 Series User’s Guide
111
• One Common and Internal Spanning Tree (CIST) that represents the entire network’s
connectivity.
• Grouping of multiple bridges (or switching devices) into regions that appear as one single bridge
on the network.
• A VLAN can be mapped to a specific Multiple Spanning Tree Instance (MSTI). MSTI allows
multiple VLANs to use the same spanning tree.
• Load-balancing is possible as traffic from different VLANs can use distinct paths in a region.
13.2 Spanning Tree Protocol Status Screen
The Spanning Tree Protocol status screen changes depending on what standard you choose to
implement on your network. Click Advanced Application > Spanning Tree Protocol to see the
screen as shown.
Figure 83 Advanced Application > Spanning Tree Protocol
This screen differs depending on which STP mode (RSTP, MRSTP or MSTP) you configure on the
Switch. This screen is described in detail in the section that follows the configuration section for
each STP mode. Click Configuration to activate one of the STP standards on the Switch.
13.3 Spanning Tree Configuration
Use the Spanning Tree Configuration screen to activate one of the STP modes on the Switch.
Click Configuration in the Advanced Application > Spanning Tree Protocol.
Figure 84 Advanced Application > Spanning Tree Protocol > Configuration
