211
Using cascade connections
LS9-16/32 Owner’s Manual
20
Other functions
6
If you want to use the Cascade Link func-
tion to link parameters and events between
two LS9 consoles, proceed as follows.
1 Move the cursor to the CASCADE LINK PORT
field, and use the dial or the [DEC]/[INC] keys to
select the port that will transmit/receive control
signals for cascade link.
You can choose from the following items.
B Move the cursor to the CASCADE COMM LINK
field, and use the dial or the [DEC]/[INC] keys to
select the item you want to link.
You can choose from the following items.
● OFF
Linking will not occur.
● CUE
The following cue-related parameters and events
will be linked.
• Cue enable/disable
• Cue mode (MIX CUE or LAST CUE)
• Cue point settings for input channels and out-
put channels
● ALL
All linkable parameters and events (including cue-
related parameters) will be linked.
• Cue-related parameters and events (see above)
• Scene recall operations
• Scene store operations
• DIMMER (MONITOR screen) operations
• Switching the fader layer
•Panel LED and display brightness (MISC
SETUP screen) operations
• Master mute group operations
7
To close the OUTPUT PORT SELECT popup
window, move the cursor to the CLOSE but-
ton (or the × symbol in the upper right) and
press the [ENTER] key.
LS9-16
Item Description
---- No port will be used.
MIDI Rear panel MIDI IN/OUT connectors
SLOT-1–
SLOT-8
Input/output channels 1–8 of a card supporting
serial communication, installed in the rear panel
slot
LS9-32
Item Description
---- No port will be used.
MIDI Rear panel MIDI IN/OUT connectors
SLOT1-1–
SLOT1-8
Input/output channels 1–8 of a card supporting
serial communication, installed in rear panel slot
1
SLOT2-1–
SLOT2-8
Input/output channels 1–8 of a card supporting
serial communication, installed in rear panel slot
2
• Control signals for cascade link and MIDI messages cannot
share the same port. If you select a port that is already speci-
fied for transmission/reception of MIDI messages, a dialog
box will ask whether it is OK to cancel the existing settings.
NOTE
