A SERVICE OF

logo

4 Replacement Procedures 4.6 Optical Drive
Installing the Optical drive
To install the optical drive, follow the steps below and refer to figures 4-6 and 4-7.
1. Seat the plastic frame on the side of the optical drive, and secure it with the
following screws.
M2×3C S-FLAT HEAD screw ×4
Stepping screw ×1
2. Slide the optical drive into the slot to connect it to the connector PJ1820 on the
system board.
3. Secure the optical drive with the following screws.
M2.5×4B FLAT HEAD screw ×2
4-18 Satellite M30-35 Maintenance Manual (960-455)