39
BUZZER :
The BUZZER option is used to determine the embedded buzzer sounding a tone to signal the
following situations. A tone lasts about two seconds long.
Situation Status
Alarm Alarm takes place
Video Loss Video loss takes place
Disk Full Disk is full
Load Default Load factory default
Buzzer Buzzer set to ON
Key Lock Enable/disable key lock function
HD3 Power on /off mobile rack HDD
Backup Backup operation complete
Timer Timer activate/deactivate
HDD Recording switching between HDD
ON : BUZZER is enabled.
OFF : BUZZER is disabled.
PASSWORD:
The PASSWORD option is used to set a 4 digit number password to prevent any unauthorized
re-formatting of the hard disk drives and to use the network viewer.
OLD PASSWORD : Enter the pre-set password (or the standard password if this is the initial
setting) to access the password setting system.
NEW PASSWORD : Enter a 4 digit number password of your choosing which will replace the
pre-set password (or the standard password “9999”).
DEFAULT :
The DEFAULT option is used to reload the factory default setting.
