Depths and Nozzle Configurations: All nozzles are identified with numbers indicating the drill size of the orifice. The
standard configuration is 11 nozzles producing depths of 4 to 6 inches depending on turf conditions. Blocked nozzle
locations are obtained by reversing the nozzle check valve ball and spring. See nozzle size chart and illustrations be-
low:
IMPORTANT: Use only nozzle configurations shown or damage to the machine may occur.
Part No.
NOZZLE SIZE AND APPROXIMATE DEPTH CHART
Drill Size Decimal Size
(inch)
Metric Size
(mm)
Quantity of Nozzles
Open
Blocked **
86–8130 #56 .0465 1.181 * *
86–8131 #53 .0595 1.511 11 0
86–8133 #46 .0810 2.057 6 5
*
Use only with varied size configurations
Approx.
Depth
*
4–6”
6–8”
Aluminum Washer is required with any nozzle change:
(S/N 29999 & Below) Part no. 80–6680
(S/N 30001 & Up) Part no. 86–8150
Part No.
86–8130
86–8133
OPTIONAL STAGGERED SIZE NOZZLE CONFIGURATION
Drill Size Decimal Size
(inch)
Metric Size
(mm)
Quantity of Nozzles
Open
Blocked **
#56 .0465 1.181 6 and 0**
#46 .0810 2.057 5 0**
Approx.
Depth
3–4”
6–8”
Aluminum Washer is required with any nozzle change:
(S/N 29999 & Below) Part no. 80–6680
(S/N 30001 & Up) Part no. 86–8150
**Additional nozzles may be blocked to compensate for pump wear.
Hydroject 3000
Page 6 – 2.1
Rev. B
Specifications
