A SERVICE OF

logo

Linear Actuator Replacement (Fig. 28)
1. Put wheels in transport position (machine raised).
2. Put the machine on a level surface, stop the engine,
engage the parking brake and disconnect engine spark
plug wires.
3. Open the hood.
4. Disconnect linear actuator wire connector.
5. Disconnect extension springs.
6. Remove capscrew and nut securing each end of
linear actuator.
Figure 28
1
2
4
4
3
7. Reverse steps 3 - 6 to install the linear actuator.
1. Linear actuator 3. Extension spring
2. Wire connector 4. Capscrew & nut
Diode (Fig. 29)
The diode is located in the wire harness under the side
control panel near the fuse.
1
Figure 28
1. Diode
HydroJect
3000 Page 5 - 29 Repairs