A SERVICE OF

logo

Open as PDF
next previous
Units
DPA Cutting
Rev. EReelmaster 6500--D/6700--D
DPA Cutting Units
Page 7.2 -- 39
5. Checkthatrollerbrushhaslight contactwithrearroll-
er (Fig. 46). If contact is incorrect, brush operation will
be adversely affected. Also make sure that brush shaft
is parallel with rear roller.
6. Lubricate grease fittings on brush housings until
grease purges past inboard seals. Wipe excess grease
from seals and fittings.
1. Driven pulley
2. Drive pulley
3. Check for alignment
Figure 44
1
2
STRAIGHT EDGE
3
Figure 45
1. Rear roller brush
2. Rear roller
3. Light contact
Figure 46
2
1
3