29
1. Introduction
Installing the driver locally
A locally connected machine is a machine directly attached to your
computer using the cable. If your machine is attached to a network,
skip the following steps below and go on to installing a network
connected machine’s driver (see Advanced Guide).
• If you are a Macintosh, Linux, or Unix OS user, refer to the
Advanced guide.
• The installation window in this User’s Guide may differ
depending on the machine and interface in use.
•Selecting Advanced Installation > Custom Installation
allows you to choose which programs to install.
• Only use a USB cable no longer than 3 meters (118 inches).
15
Windows
1
Make sure that the machine is connected to your computer
and powered on.
If the “Found New Hardware Wizard” appears during the
installation procedure, click Cancel to close the window.
2
Insert the supplied software CD into your CD-ROM drive.
Click Start > All programs > Accessories > Run.
X:\Setup.exe replacing “X” with the letter, which represents
your CD-ROM drive and click OK.
3
Select Install Now.
4
Read the License Agreement, and select I accept the terms
of the License Agreement. Then, click Next.
5
Follow the instructions in the installation window.
