6. If more than one input devices is connected, press the Source button repeatedly
to switch among devices.
7. To turn off the projector, press the Power button. The projector prepares for
shutdown, and a ″Wait a moment please...″ message appears.
8. When the ″Power off?/Press Power again″ message appears, press the Power
button. The projector turns off.
Note: The projector will enter a cool down mode, and the fans will continue to
run for approximately 90 seconds. Do not remove power to the projector
until the fans have stopped.
9. Turn off the room light and leave.
Note:
Leave the power cable plugged in for at least 2-5 minutes until the projector
returns to room temperature before placing the projector inside the soft case.
Placing the projector into the case too soon after switching off the power
could cause the projector to over heat.
Attention
Before moving the projector, be sure to power down the projector normally
and disconnect the projector from the main power source.
Adjusting the projector height
To adjust the projector height, complete the following procedure:
1. To raise the height of the projector, lift the projector as shown in 1 and press
the elevator-foot buttons as shown in 2. The elevator foot drops down as
shown in 3.
2. To lower the height of the projector, press the elevator-foot button as shown in
2 and push down on the top of the projector.
3. To make adjustments to the level, rotate the leveling foot as shown in 4.
2-2 E500 Projector: User’s Guide
