Chapter 2. Setting up the projector
This chapter provides information on starting and shutting down the projector,
adjusting the projector height and level, adjusting the zoom, focus, and keystone,
and adjusting the volume.
Attention
Before moving the projector, be sure to power down the projector normally
and disconnect the projector from the main power source.
Starting and shutting down the projector
Please follow the steps below to start the projector and to shut down the projector.
1. Connect the power cord to the projector as shown below. Connect the other
end to a wall outlet. The Power LED and Lamp-ready LED turn on.
2. Remove the lens cover.
3. Connect to an input device.
4. Turn on the connected devices.
5. Ensure that the Lamp-ready LED is on a steady amber, then press the Power
button to turn on the projector.
The projector splash screen displays and connected devices are detected. If the
connected device is a ThinkPad, press Fn + F7 on the computer keyboard to
switch the display output to the projector. Check the user’s manual of non-
Lenovo PCs to determine the appropriate Fn hot keys to change display output.
Attention
Do not look directly into the projection lens when the lamp is turned on.
The bright light may harm your eyes
© Copyright Lenovo 2005. © Portions Copyright IBM Corp. 2004. 2-1
