C650 3-9
Using fax/scan functions
3
Using fax/scan functions Chapter 3
2
Select the desired destination.
– The last five destinations where a transmission was sent are displayed.
– To cancel a selection, touch the button for a selected destination again.
Selecting a destination with an LDAP search
Follow the procedure described below to search for an E-mail address
registered with the LDAP server and select the destination.
!
Detail
In order to perform an LDAP search, LDAP must be enabled and an LDAP server
must be registered. For details on specifying LDAP settings, refer to the User’s
Guide [Network Scanner Operations].
If “Manual Destination Input” in Administrator mode is set to “Restrict”, the LDAP
search feature is not available. For details on specifying the setting for the
“Manual Destination Input” parameter, refer to the User’s Guide [Network
Scanner Operations]. If user authentication is applied, whether or not to accept
"Manual Destination Input" is specified for each registered user. For details on the
user registration, refer to the User's Guide [Copy Operations].
