108 Fine-Tuning the Projector
Ppower
button). Enable Sleep Mode if you want the projector
to turn off automatically if it is idle (and no signal is received) for
10 minutes (you can adjust the amount of time using the
Sleep
Mode Timer
setting). Enable High Altitude Mode when you are
using the projector above 4,900 feet (1,500 meters). Enable
BNC
Sync Termination
when analog (75Ω) termination (such as for
switchers) is necessary.
■ Standby Mode
Select Network On to enable the projector to be monitored over
a network when it is in standby mode (the power light is orange).
■ Projector ID
Lets you assign a numeric ID to each projector. When you are
using multiple projectors, you can use the ID to select the one you
want to operate with the remote control. See page 57 for
instructions.
■ Multi-screen
Use this option if you want to color-match two or more projectors
that are being used to display images near each other, or you are
using the multi-screen feature to project from one source (one
image) with multiple projectors (see the EasyMP Operation
Guide). You can make image adjustments at each of five
adjustment levels. First choose an
Adjustment Level and then
adjust the settings for each level:
Brightness Correct to adjust
the brightness, and
Color Correct to adjust the balance between
red and green, or blue and yellow. See page 109 for more
information about multi-screen color adjustment.
■ Language
Select from 20 languages to be used for the projector menus.
note
If Direct Power On is
enabled, the power cord is
connected, and a power
outage occurs, the projector
will start when the power is
restored.
Do not use the projector at
altitudes above 7,500 feet
(2,286 meters).
