EPSON PowerLite 8300i Projector
5/03 EPSON PowerLite 8300i Projector - 13
5. If your network does not assign addresses automatically,
turn off
DHCP and enter the projector’s IP Address,
Subnet Mask, and Gateway Address, as needed.
Note: To enter numbers using the remote control, press the
Num button until it lights, then use the number keypad.
6. After changing an address in the network menu, press the
Enter button. This stores the value.
7. When done making all necessary changes, press
ESC to exit
the menu system.
Registering Projectors in EMP Monitor
Before you can monitor a projector, you have to register it.
Follow these steps:
1. Open EMP Monitor by selecting
EMP Monitor from the
Start menu. You see this screen:
2. Click
Register projector as shown.
You see this screen:
3. Click Auto detect to locate projectors currently operating
on the network. Or click
Manual registration and enter the
projector’s name and network address.
Any projectors found on the network are listed as shown
below:
4. Select the projectors you want to add by clicking their
name. Then click
Add, and on the next screen click Close.
You see your registered projectors listed on the main EMP
Monitor screen.
Monitoring Your Projectors
The EMP Monitor screen lets you monitor your projectors
using the Status, Video Source, and Error icons shown below.
This lets you see which projectors are currently being used,
from which source (or port) they are projecting an image, and
if a problem occurs.
For detailed status information, select the projector in
question and click
View details.
Note: To monitor a projector when it’s in standby mode (plugged
in but not projecting), you must have selected
Network ON as the
Standby Mode setting in the projector’s Advanced1 menu.
Click here
Click here
Click here
Status icon Video Source icon Error icon
