A SERVICE OF

logo

Open as PDF
next previous
Replacing the Lamp - 85
Replacement Method
1
Switch off the power supply, allow the projector to cool down*, and then disconnect the
power cord.
The amount of time required for the projector to cool down will depend on the surround-
ing temperature.
2
Once the projector has cooled down sufficiently, remove the fan.
· Approximately sixty minutes are required for the projector to cool down sufficiently.
· Remove the two screws holding the fan in place.
3
Withdraw the lamp.
Loosen the three screws holding the lamp in place, and then pull the lamp out towards
you.
4
Attach a new lamp.
Align the direction, push the lamp in as far as it will go, and then secure it in place with
the three screws.