24
Connecting to a Video Source
Playing Sound from the Video Equipment
The projector has a single built-in speaker with a maximum output of 1 W.
You can output composite video and S-Video sound through the projector's
built-in speaker by connecting the video equipment's audio output port
equipment to the Audio 2 port (RCA/monaural) at the rear of the projector
using the A/V cable that is included with the projector.
If you would like to output sound from a component video and RGB video
that is being used as the source for image signals via the Computer/
Component Video port, refer to "Playing Sound from the Computer".
p.18
Use the following procedure to adjust the volume of the sound output.
PROCEDURE
Press the [Menu] button on the remote control, and
then select "Volume" from the "Audio" menu.
For details on this operation, refer to "Using the Configuration
Menus".
p.57
Use the [ ] and [ ] buttons to adjust the volume.
The volume is increased or reduced each time a button is
pressed.
After making the adjustment, press the [Menu] button
to exit the configuration menu.
A/V cable (white/red)
(accessory)
To audio output port
To Audio 2 port
red
white
1
Reset
Execute
:
Audio Input
Audio 1 Audio 2
+
-
Video
Audio
Setting
User's Logo
Advanced
About
Reset All
Volume
10
[ESC]: Return [ ]: Select [ ]: Adjust [Menu]: Exit
2
Video
Audio
Setting
User's Logo
Advanced
About
Reset All
Reset
Execute
:
Audio Input
Audio 1 Audio 2
+
-
Volume
15
[ESC]: Return [ ]: Select [ ]: Adjust [Menu]: Exit
3
