Departmental Switch Model DS-16B Hardware Reference Manual
Switch Management
After changing any of the following menus from the front panel or Telnet
connection, you must reboot the switch for the changes to take effect.
Ethernet IP Address Pressing <Enter> while Ethernet IP address is selected, displays
the switch’s Ethernet IP address:
The switch’s default IP address, as shown, is a temporary address
derived from the switch’s WWN. Enter a valid IP address.
To enter an IP address
1. Use <Up> and <Down> to increment or decrement the displayed
value. The underlined cursor indicates the numbers to modify.
When entering a number, <Up> and <Down> start in the slow
mode and move to the fast mode if the button is held down. The
numbers go to a maximum of 255 and wraps to zero; for a large
number, it may be faster to use the <Down> button.
2. After entering a number, press <Tab/Esc> to move the cursor to
modify the next field.
3. After setting the IP address, pressing <Enter> stores the value.
Ethernet Subnetmask Pressing <Enter> while
Ethernet Subnetmask is selected, displays:
.
Set QuickLoop Port
Unset QuickLoop Port
QuickLoop Partner WWN
Reset to Default 3-16
Table 3-4 Configuration Menu (continued)
Configuration menu See Page
Ethernet IP address:
10.
00. 00. 10
Ethernet Subnetmask
none
