159
Responding to Error Messages
Connection is in progress by other access points in Pushbutton
Connection mode (PBC mode) of Wi-Fi Protected Setup (WPS).
X Wait a while before trying to establish the connection, or try to
establish a connection in PIN code connection mode (PIN mode)
(p.62, 111).
A problem other than error number 11 to 69 occurred.
X Turn off and on the camera’s power switch.
Has the procedure to establish a connection between
cameras been performed on the other camera as well?
X Perform the procedure to establish a connection between cameras
on the other camera as well.
X When reconnecting cameras for which connection settings have
been registered, perform the reconnection procedure on both
cameras.
Is connection being attempted by multiple cameras?
X The camera can be connected to only one camera at a time.
Confirm that no other camera is attempting to establish a
connection nearby and retry connection.
Does the card in the camera to receive data have sufficient space?
X Check the card in the camera to receive data. Replace the card or
make sufficient space available, then try sending the data to the
camera again.
Is the card in the camera to receive data locked?
X Check the card in the camera to receive data. Release the lock,
then try sending the data to the camera again.
69: Multiple wireless LAN terminals have been found.
Cannot connect. Retry from the beginning.
91: Other error
101: Could not establish connection
102: Could not send files
