59
Preamble Type
The “Long Preamble” can provide better
wireless LAN compatibility while the “Short
Preamble” can provide better wireless LAN
performance.
IAPP
If you enable “IAPP”, it will allow wireless station
roaming between IAPP enabled access points
within the same wireless LAN.
Protection This is also called CTS Protection. It is
recommended to enable the protection
mechanism. This mechanism can decrease the
rate of data collision between 802.11b and
802.11g/802.11n wireless stations. When the
protection mode is enabled, the throughput of
the AP will be a little lower due to many of frame
traffic should be transmitted.
Aggregation This function is used to join multiple data
packets for transmission as a single unit to
increase network efficiency.
Short GI
The 802.11n draft specifies two guard intervals:
400ns (short) and 800ns (long). Support of the 400ns
GI is optional for transmit and receive. Enable this
function will increase network efficiency.
WLAN Partition
Enable this function and all the wireless clients cannot
access to each other.
RF Output Power
You can set the output power of wireless radio.
Unless you’re using this wireless router in a
really big space, you may not have to set output
power to 100%. This will enhance security
(malicious / unknown users in distance will
not be able to reach your wireless router).
Click <Apply Changes> at the bottom of the screen to save the above configurations.
3.2.5 Wireless Schedule
This page allows you to set up the wireless schedule rules. You can designate to enable wireless
interface by time or day.
