41
Parameters Default Description
IP address
192.168.2.1 This is the router’s LAN IP address (Your LAN
clients default gateway IP address).
Subnet Mask
255.255.255.0 Specify a Subnet Mask for your LAN segment.
Default Gateway
Specify the default gateway for LAN segment.
DHCP
Server By selecting the DHCP server, the router will
automatically give your LAN clients an IP
address. If the DHCP server is not enabled then
you’ll have to manually set your LAN client’s IP
addresses; make sure the LAN Client is in the
same subnet as this broadband router if you
want the router to be your LAN client’s default
gateway.
DHCP Client Range
You can configure a particular IP address range
for your DHCP server to assign IP addresses to
your LAN Clients.
Note: By default the IP range is from: Start IP
192.168.2.100 to End IP 192.168.2.200. If you
want your PC to have a static/fixed IP address
then you’ll have to choose an IP address outside
this IP address range.
802.1d Spanning Tree
Disabled If 802.1d Spanning Tree function is enabled, this
router will use the spanning tree protocol to
prevent from network loop happened in the LAN
ports.
