clear spantree portpri 317
clear spantree
portpri
Resets to the default value the priority of a network port or ports for
selection as part of the path to the STP root bridge in all VLANs on a
wireless LAN switch or controller.
Syntax —
clear spantree portpri port-list
■ port-list — List of ports. The port priority is reset to 32 (the default)
on the specified ports.
Defaults — None.
Access — Enabled.
History — Introduced in MSS Version 3.0.
Usage — This command resets the priority in all VLANs. To reset the
priority for only specific VLANs, use the clear spantree portvlanpri
command.
Examples — The following command resets the STP priority on port 6 to
the default:
WX1200# clear spantree portpri 6
success: change accepted.
See Also
■ “clear spantree portvlanpri” on page 318
■ “display spantree” on page 320
■ “set spantree portpri” on page 337
■ “set spantree portvlanpri” on page 339
clear spantree
portvlancost
Resets to the default value the cost of a network port or ports on paths to
the STP root bridge for a specific VLAN on a wireless LAN switch, or for all
VLANs.
Syntax —
clear spantree portvlancost port-list {all | vlan
vlan-id}
■ port-list — List of ports. The port cost is reset on the specified
ports.
■ all — Resets the cost for all VLANs.
