Filter
Top Products
5
32
26
37
6. Remove the backing from the Adhesive Clip (37). Press
the Adhesive Clip onto the left side of the Frame (32) in
the indicated location. Press the Allen Wrench (26) into
the Adhesive Clip.
Make sure the walking belt is properly tightened (see
SYMPTOM 3 on page 8).
7. Make sure that all parts are properly tightened before you use the treadmill. T
o protect the floor or car
-
pet, place a mat under the treadmill.
4
4. Insert the Reed Switch (7) into the Reed Switch Clip
(14) as shown.
Attach the Reed Switch Clip to the left
side of the Frame (32) with an M4 x 16mm Screw (3).
Do not fully tighten the Screw yet.
Refer to the inset drawing. Locate the Magnet (15) on
the left Flywheel (12). Turn the Flywheel until the
Magnet is aligned with the Reed Switch (7). Slide the
Reed Switch so that there is a 1/8” gap between the
Reed Switch and the Magnet. Then, tighten the M4 x
16mm Screw (3).
3
14
7
32
1
33
5. The Console (1) requires two "AA" batteries (not includ-
ed). Alkaline batteries are recommended. Remove the
Battery Cover (33) by sliding it upward. Insert two batter-
ies
into the battery clip,
making sure that the negative
(–) ends of the batteries are touching the springs in
the battery clip. Insert the battery clip back into the
Console and slide the Battery Cover (33) back into
place.
5
Batteries
Battery Clip
15
12
3
7
1/8”
Top View
6