Filter
Top Products
7
ASSEMBLY
Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Assembly requires the included allen wrench
and your own phillips screwdriver .
Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal
condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off
the lubricant with a soft cloth and a mild, non-abrasive cleaner.
1. With the help of a second person, carefully raise the
Uprights (61) until the treadmill is in the position shown.
Identify the Right Extension Leg (101) by looking at the
sticker on the underside. Insert the Right Extension Leg
into the right side of the treadmill as shown. (Note: It may
be helpful to tip the Uprights (61) in the direction shown
by the arrow as you insert the Extension Leg.) Attach the
Extension Leg with a Long Extension Leg Screw (18).
Make sure to push on the head of the Extension Leg
Screw while tightening it.
Attach the Left Extension Leg (not shown) in the same way.
2. Insert the upper end of a Handrail (53) into the right
Upright (61) as shown. Note: It will be necessary to
pivot the Handrail to the side and back repeatedly
(see arrow A) while pushing on the Handrail (see
arrow B) to insert it fully into the Upright. Next, pivot
the lower end of the Handrail down and push it against
the bracket on the Right Extension Leg.
Insert the other Handrail (53) into the left Upright (61) in
the same way.
101
Bracket
18
61
1
Bracket
61
61
53
53
2
B
A
3. Make sure that the hole in the Handrail (53) is aligned with
the hole in the bracket on the Extension Leg (101). If the
holes are not aligned, rotate the Handrail away from the
treadmill and slide the upper end of the Handrail out of the
Upright (61) slightly. Then, rotate the lower end of the
Handrail back to the position shown by the dotted line in
drawing 2. Repeat, if necessary, until the holes are
aligned. Make sure that the lower end of the Handrail is
against the bracket on the Extension Leg. Using the in-
cluded allen wrench, tighten a Handrail Screw (77) into
the bracket and the Handrail.
Attach the other Handrail (not shown) in the same way.
53
101
77
61
3