Filter
Top Products
7
3. Orient the Right Upright (36) as shown, and at-
tach it to the Base (48) with two Upright Bolts
(27) and two Upright Star Washers (39); do not
tighten the Upright Bolts yet.
48
36
39
39
27
3
4. Set the Base (48) near the front of the treadmill,
with the Power Cord (13) on the Hood (1) as
shown.
Cut the small tie (not shown) holding the Upright
Wire (28) in a bundle.
Wrap the strap around the Upright Wire (28) and
secure the strap using the included plastic tie.
Then, pull the opposite end of the strap until the
end of the Upright Wire is pulled through the
Right Upright (36).
Raise the Uprights (31, 36) so that the Base (48)
is flat on the floor. Make sure that the end of the
Upright Wire (28) does not fall into the Right
Upright.
4
Strap
28
Tie
48
28
36
31
13
1
Large
Hole
2. Have a second person orient the Base (48) as
shown.
Identify the Left Upright (31), which has a large
h
ole near the bend as shown.
Orient the Left Upright (31) as shown, and attach
it to the Base (48) with two Upright Bolts (27) and
two Upright Star Washers (39); do not tighten
the Upright Bolts yet.
48
27
27
39
39
31
Bend
Large Hole
Bend
2
36