5
1. With the help of a second person, carefully raise the
treadmill to the upright position.
While the other person tips the treadmill to one side and
holds it, insert an Extension Leg (59) into one side of
the Base (32). Make sure that the Extension Leg is
turned so the bracket is on the side shown. Using the
Allen Wrench (102), tighten an Extension Leg Screw
(57) into the Extension Leg and the Base. Attach the
other Extension Leg in the same manner.
2. Refer to HOW TO LOWER THE TREADMILL FOR
USE on page 11. Follow the instructions in step 2 to
lower the treadmill.
Cut the plastic ties holding the cage nuts in the upper
end of each Handrail (60, 62).
Position the Left Handrail (60) on the left Upright (32) as
shown. The bracket on the Extension Leg (59) should
be inside of the lower end of the Left Handrail (see the
inset drawing). Thread two Handrail Bolts (30) with
Handrail Washers (40) into the left Upright and the Left
Handrail. Do not tighten the Handrail Bolts yet.
While another person holds the Console Base (46),
insert all excess Wire Harness (35) through the Right
Handrail (62) and into the right Upright. Next, attach the
Right Handrail in the same way that you attached the
Left Handrail. Be careful to avoid damaging the Wire
Harness (35).
57
102
59
32
Bracket
60
46
30
30
30
40
32
59
35
62
30
40
1
2
ASSEMBLY
Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Assembly requires the included allen wrench
and your own phillips screwdriver , adjustable wrench , and scissors .
Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a
small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This is a normal
condition and does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off
the lubricant with a soft cloth and a mild, non-abrasive cleaner.
59