Filter
Top Products
6. Attach the Storage Latch (14) to the left Upright (11) with
the two Screws (96). Be careful not to overtighten the
Screws.
Refer to step 4. Tighten the Handrail Nuts (93).
7. Make sure that all parts are properly tightened before
you use the treadmill. Keep the included allen wrench
in a secure place. (The allen wrench is used to adjust the
walking belt [see page 13]). To protect the floor or carpet,
place a mat under the treadmill.
96
14
11
6
3. Refer to drawing 3a. If there is a plastic tie in the Cage
Nut (70) in the Right Handrail (88), remove the plastic tie.
Pull 6” of the Wires (21) out of the Right Upright (11).
Route the Wires up through the bracket on the Right
Handrail and out of the upper end as shown. (If neces-
sary, use needle-nose pliers to grip the ends of the Wires.)
Thread the included plastic tie through the indicated
holes in the Right Handrail.
Refer to drawing 3b. Look into the Right Handrail (88)
and make sure that the Wires (21) are on the indicated
side of the plastic tie. Then, tighten the plastic tie and cut
off the end.
Refer to drawing 3c. Insert the bracket on the Right
Handrail (88) into the right Upright (11), with the lower
end of the Right Handrail beside the Extension Leg (34 ).
Tighten a Short Handrail Bolt (89) with a Small Handrail
Washer (39) into the upper end of the Upright.
Attach the Left Handrail (1) as described above. Note:
There are no wires in the left Upright (11).
11
11
1
39
89
34
88
3c
4. Attach the lower end of the Right Handrail (88) to the
Extension Leg (34) with a Handrail Bolt (91), a Handrail
Washer (92), and a Handrail Nut (93) as shown. Do not
tighten the Handrail Nut yet. Note: It may be necessary
to push on the lower end of the Handrail to align the hole
in the Handrail with the hole in the Extension Leg.
Attach the Left Handrail to the left Extension Leg (not
shown) as described above.
4
92
91
93
34
88
6
96
96
88
21
88
21
46
46
1
5a
5b
5. Place the Console Base (46) on the Handrails (88, 1) (the
Left Handrail is not shown). Pull out the two Wires (21)
just enough to connect them to the two connectors in the
Console Base. Plug the Wires fully into the connec-
tors. WARNING: Do not disconnect or connect the
Wires while the treadmill power cord is plugged in.
Refer to drawing 5b. Thread four Screws (96) into the
Right and Left Handrails (88, 1) and the Console Base
(46). Make sure that the Wires (21) in the Right
Handrail are clear of the screw holes. After all four
Screws have been started, tighten the Screws until
they are snug; do not overtighten the Screws.
21
88
70
11
Tie
3a
3b
21
88
Tie