Filter
Top Products
4. Remove the shipping tie from the Left Handrail (4)
and Handrail Spacer (3). Attach the Left Handrail and
Handrail Spacer to the left Upright (38) with two
Handrail Bolts (1) and Handrail Washers (70) as
shown. Make sure that the ramps on the Handrail
Spacer is on the inside as shown. Do not tighten the
Handrail Bolts until step 5 is completed.
Remove the shipping tie from the Right Handrail (32)
and Handrail Spacer (3). Hold the Handrail Spacer
against the right Upright (38) and feed the excess
Wire Harness (53) into the right Upright. Attach the
Right Handrail and Handrail Spacer to the right
Upright with two Handrail Bolts (1) and Handrail
Washers (70). Do not tighten the Handrail Bolts
until step 5 is completed.
5. Set the Console Base (67) on the Handrails (4, 32).
Route the Wire Harness (53) as shown. Attach the
Wire Harness to the Right Handrail (32) with the
Harness Clip (103) and a Handrail Screw (5); do not
fully tighten the Handrail Screw yet. Then loosely
thread the other three Handrail Screws (5) into the
Console Base. After all four Screws are threaded, firm-
ly tighten the Screws. Be careful not to overtighten
the Screws. Insert the excess Wire Harness (53) into
the Right Handrail.
Tighten the four Handrail Bolts (1) used in step 4.
6. Remove the backing from the Adhesive Clip (80).
Press the Adhesive Clip onto the right Upright (38) in
the indicated location. Press the Allen Wrench (81)
into the Adhesive Clip.
7. The Console (11) requires three "AA" batteries (not
included); alkaline batteries are recommended.
Open the Battery Cover (12) as shown. Press three
batteries into the battery compartment, with the nega-
tive (Ð) ends of the batteries touching the springs.
Close the battery cover, push up on the battery cover
tab, and then push the tab forward as shown in the
inset drawing. Be sure that the tab locks into place.
8. Make sure that all parts are tight before you use
the treadmill. (Note: The ratchet screws shown at the
far right are factory set and should not be adjusted.)
To protect the floor or carpet from damage, place a
mat under the treadmill.
4
6
70
1
4
3
32
3
38
38
Ramps
53
70
1
6
7
81
38
80
11
12
Batteries
Battery Cover Tab
5
67
32
4
5
53
103
5
Ratchet
Screws