Filter
Top Products
1. Note that the Right Handrail (32) and the Console
Base (not shown) are connected to the treadmill by
the Wire Harness (53). During assembly steps 1
through 5, be careful to avoid pulling on or dam-
aging the Wire Harness.
With the help of a second person, carefully lay the
treadmill onto one side. Insert one of the Base Legs
(44) into the Upright (38) as shown. Make sure that
the Base Leg Pad (33) is in the indicated position.
Using the included Allen Wrench (81), attach the
Base Leg with a Base Leg Screw (39).
Attach the other Base Leg (44) as described above.
With the help of a second person, carefully raise the
treadmill to the upright position so that both Base
Legs (44) are resting flat on the floor.
2. Carefully lower the treadmill. Remove the two indi-
cated Latch Screws (14) and the shipping bracket
from the left Upright (38). Save the Latch Screws
for use in assembly step 3; discard the shipping
bracket.
3. Remove the two remaining Latch Screws (14) from
the left Upright (38).
Without removing the tape from the Latch Bracket
(16) and the Latch Spacer (13), attach both parts to
the left Upright (38) with the four Latch Screws (14).
Make sure that the Latch Screws are tight, but
do not overtighten them; if the Latch Screws are
overtightened, the Storage Latch (17) will not
slide smoothly. Remove any visible tape from the
Latch Bracket and the Latch Spacer.
Note: The inset drawing shows how the Latch
Bracket (16), Latch Springs (15), Storage Latch (17),
and Latch Spacer (13) fit together.
2
1
5
81
44
39
38
44
33
33
39
32
53
Shipping
Bracket
14
38
ASSEMBLY
Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not
dispose of the packing materials until assembly is completed. Assembly requires the included allen wrench
and your own phillips screwdriver , adjustable wrench , and
scissors .
14
16
17
13
38
3
13
16
17
15