Filter
Top Products
8
5. Have a second person lift and hold the front end
of the Frame (59). Hold a Frame Spacer (84) be-
tween the Right Handrail (81) and the Frame.
Attach the Right Handrail to the Frame with an
M10 x 110mm Bolt (3), an M10 Washer (12), and
an M10 Star Washer (10). Do not tighten the
Bolt yet.
Repeat this step on the left side of the tread-
mill.
84
59
10
3
12
81
4. With the help of a second person, raise the
Handrails (80, 81) so the Base (87) is flat on the
floor as shown. Next, position the front of the
t
readmill Frame (59) between the Handrails.
S
ee the inset drawing. Locate the wire tie in-
side of the lower end of the Right Handrail (81).
Secure the wire tie to the Wire Harness (83).
Then, pull the upper end of the wire tie until the
end of the Wire Harness is extending from the
hole in the upper end of the Right Handrail.
Attach a Wheel (85) to the Base (87) with an M10
x 80mm Bolt (5) and an M10 Jam Nut (14).
Attach the other Wheel (not shown) in the
same way.
87
14
85
5
81
59
4
83
81
5
80
W
ire Tie
Wire
Tie
83