Filter
Top Products
8
1
27
Tab
6. The Console (1) requires two “AAA” batteries. Alkaline
batteries are recommended. Press the indicated tab on
the Battery Cover (27), and remove the Battery Cover.
I
nsert two batteries into the two battery clips; make
sure that the negative (–) ends of the batteries are
t
ouching the springs in the battery clips.
9. Make sure that all parts are properly tightened before you use the treadmill. To protect the floor or car-
pet, place a mat under the treadmill.
Batteries
6
7. See drawing 7a. Hold the Console (1) near the
Handrail (5). Connect the wire on the Console to the
Handrail Wire (2). Attach the Console to the Handrail
with two M4 x 12mm Screws (3). Make sure that the
wires are not pinched.
See drawing 7b. Press the Battery Cover (27) back
onto the Console (1).
29
20
30
8. Remove the paper backing from the Adhesive Clip (30).
Press the Adhesive Clip onto the left side of the Frame
(29) in the indicated location. Press the Hex Key (20)
into the Adhesive Clip.
Make sure that the walking belt is properly tightened
(see SYMPTOM 3 on page 12).
8
27
3
1
1
2
7a
7b
5