Filter
Top Products
ASSEMBLY
Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials; do not
dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking
belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to
the top of the walking belt or the shipping carton. This does not affect treadmill performance. If there is lubricant
on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.
Assembly requires the included allen wrenc=_ and your own phillips screwdriver (_]_=====- ,
two adjustable wrenches _ and 9/16 socket wrench _ .
1. With the help of a second person, carefully raise the
Right and Left Handrails (6, 7) to the position shown. Be
careful net to pull on the Wire Harness (22) as you raise
the Uprights.
22
2. With the help of a second person, carefully tip the tread-
mill onto its right side. Hold the Base (80) against the Left
Upright (7) and the Right Upright (not shown). Make sure
the Base Pads (19) are on the bottom.
Using a 9/16 socket wrench and an adjustable wrench,
attach the Base (80) to the Left Upright (7) with two
Upright Bolts (62), two Washers (11), and two Upright
Nuts (17). Do not tighten the Upright Bolts yet. Attach
the Base to the Right Upright (not shown) with two Upright
Bolts (12), two Washers (11), and two Upright Nuts (17).
Then, tighten all four Upright Bolts (62).
Tip the treadmill back to the position shown in step 1.
2
11
62
3. Insert the Wire Harness (22) into the Right Upright (7) as
you insert the Handrail (16) into the Right and Left
Uprights (7, 6). Be careful not to pinch the Wire
Harness. Tighten a Handrail Bolt (12) with a Washer (11)
into each Upright.
Loosen the two Console Bolts (9) underneath the
Console (1). Rotate the Console to the position shown
and tighten the two Console Bolts.
9
16