12
HOW TO ADJUST THE RESISTANCE BELT
If the pedals do not have enough resistance, even
when the resistance knob is turned to the maximum
setting, the Resistance Belt (49) may need to be
adjusted. To adjust the Resistance Belt, the left side
shield must first be removed. Refer to the instructions
on page 11 to remove the left side shield.
Next, turn the
resistance knob
to the lowest
setting. (See
HOW TO
ADJUST THE
PEDALING
RESISTANCE
on page 9.)
Locate and grip
the end of the
Resistance Belt
(49). Peel the
end of the
Resistance Belt
down as shown
in the inset
drawing. Tighten
the Belt by pulling it slightly and then refasten the end
of the Belt. Turn the Crank (7) for a moment to make
sure that there is not too much resistance. When the
Resistance Belt is properly adjusted, reattach the left
side shield and pedal.
BATTERY REPLACEMENT
If the console does not function properly, the batteries
should be replaced. See assembly step 3 on page 6.
49
49
1
7