Filter
Top Products
7
5. Identify the Right Pedal (63), which has an “R”
molded into its bottom surface.
Attach the Right Pedal (63) to the Right Pedal
T
ube (64) with two M8 x 1 9/16" Hex Bolts (41),
two M8 Washers (52), and two M8 Nylon
Locknuts (57).
Attach the Left Pedal (not shown) to the Left
Pedal Tube (not shown) in the same way.
6. Apply a small amount of the included grease to
the parts shown at the right.
Attach the Right Pedal Tube (64) to the Right
Handlebar Leg (71) with an M8 x 2 1/2"
Shoulder Hex Bolt (40), an M6 Washer (55),
and an M6 Nylon Locknut (56).
Repeat this step to attach the Left Pedal
Tube (not shown) to the left side of the ellip-
tical exerciser.
52
52
4
1
64
63
57
71
64
40
5556
6
5
7. Insert a Plastic Sleeve (16) into the top of the
Right Handlebar Leg (71). Then, insert a
Handlebar (6) into the Right Handlebar Leg.
Align the holes in the Handlebar with the holes
in the Right Handlebar Leg. Attach the
Handlebar with two M6 x 5/8" Pocket Screws
(46), two M6 Arc Washers (39), and two M6
Nylon Locknuts (56).
Attach the other Handlebar (6) to the Left
Handlebar Leg (5) in the same way.
46
39
16
56
71
6
6
5
7
8. Make sure that all parts of the elliptical exer
-
ciser are properly tightened. Note: Some
hardware may be left over after assembly is
completed.
To protect the floor or carpet from
damage, place a mat under the elliptical
exerciser.
39