Filter
Top Products
4
1.
Raise the Handlebar Frame (7) to the position shown.
Hold the Handle (20) and hook the Link Arms (4) onto
the lower Rollers (33) on the Handlebar Frame.
Tap two Round Endcaps (8) onto the stabilizer at the
front of the Frame (6). Tap two Round Endcaps onto
the stabilizer at the rear of the Frame (not shown).
2. Turn the Seat Knob (38) to loosen it. Pull down the
Seat Knob and slide the Seat (3) onto the Seat Frame
(5). Slide the Seat to the desired position and release
the Seat Knob. Retighten the Seat Knob. Push on the
Seat to make sure that the Seat Knob is engaged in
one of the holes in the underside of the Seat
Frame.
3.
Press the two Domed Endcaps (13) onto the upper
end of the Handlebar Frame (7).
Insert the Handlebar (2) into the Handlebar Frame (7).
The sides of the Handlebar must bend toward the seat
(not shown). Tighten the four #8 x 1/2” Screws (16)
into the Handlebar Frame and the Handlebar.
4.
The Monitor (1) requires two “AA” batteries (not
included); alkaline batteries are recommended.
Insert two “AA” batteries into the battery clip inside the
back of the Monitor. Make sure that the negative (-)
ends of the batteries are touching the springs in the
battery clip.
1
33
4
20
7
8
6
13
7
2
16
38
3
5
3
ASSEMBLY
Place all parts of the CARDIO GLIDE PLUS in a cleared area and remove the packing materials. Do not dispose
of the packing materials until assembly is completed. Read each step carefully before beginning. THE
FOLLOWING TOOLS ARE REQUIRED FOR ASSEMBLY: The included pedal tool , and your own
phillips screwdriver and rubber mallet .
2
Batteries
Clip
1
4