Filter
Top Products
7
2. Open part bag B. Press the Right Frame Spacer (13) and
the Left Frame Spacer (not shown) onto the sides of the
Frame (55) as shown.
Make sure that the high side of
each Spacer is facing forward as shown. With the help
of a second person, carefully lift the Frame (55) and hold
the Spacers between the plates on the Uprights (89).
Align the hole in the plate on the Right Upright (89) with
the hole in the Right Frame Spacer (13). Loosely thread a
5” Bolt (10) and a 3/8” Star Washer (45) into the Spacer
and the Frame (55). Repeat this step on the left side of
the treadmill.
See drawing 2a. With the help of a second person, care-
fully tip the treadmill onto its left side as shown.
Feed the Wire Harness (22) into the large round hole near
the lower end of the Right Upright (89), and then pull the
Wire Harness out of the upper end as shown.
3. Open part bag C. With the help of a second person,
raise the Left and Right Uprights (88, 89) to the vertical
position.
Identify the Right Handrail (6), which has a large hole in the
left side. Feed the Wire Harness (22) into the rectangular
bracket on the Right Handrail and out of the large hole.
(Note: It may be helpful to use needlenose pliers to pull the
Wire Harness out of the hole.) Press a Handrail Cap (83)
onto the lower end of the Right Handrail as shown.
Insert the rectangular bracket on the Right Handrail (6)
into the right Upright (89). Attach the Right Handrail and
the Handrail Cap (83) with three 1” Bolts (12) and two 1/4”
Washers (108) as shown.
Do not tighten the Bolts yet.
Attach the Left Handrail (7) as described above. Note:
There is not a wire harness on the left side.
22
Hole
12
12
12
6
12
12
12
108
7
108
88
83
89
108
83
3
45
10
13
High
side
Plate
89
55
2
2a
22
22
89