Filter
Top Products
8
5. Set the Console (78) on the Left and Right Uprights (9,
10). Be careful not to pinch any wires. See drawing 4
above. Make sure that the Wire Harness (17) is
not in
the small cutout shown by the arrow.
Attach the Console (78) to the Uprights (9, 10) with six
3/4” Screws (70).
Start all six Screws before tighten-
ing any of them; be careful not to overtighten the
Screws.
78
10
9
70
70
5
70
4. Cut the tie securing the upper end of the Wire Harness
(17).
Have a second person hold the Console (78) near the
R
ight Upright (10). Attach the ground wire from the
Console to the Right Upright with the 1/2” Silver Screw
(87).
Connect the Wire Harness (17) to the wire harness on
the Console (78). Make sure to connect the connec-
tors properly (see the inset drawing). The connectors
should slide together easily and snap into place. IF
THE CONNECTORS ARE NOT CONNECTED PROP-
ERLY, THE CONSOLE MAY BE DAMAGED WHEN
THE POWER IS TURNED ON.
Insert the connectors into
the Console.
87
17
10
4
7
8
Ground
Wire
17
6. Lower the Uprights (9, 10) until the handrails are touch-
ing the floor.
See the lower drawing. Position the Uprights (9, 10) so
that the treadmill Frame (12) is centered between them.
Firmly tighten the four 3” Bolts (47). Then, raise the
Uprights (9, 10) back to the vertical position.
9
9, 10
Handrail
12
10
Top View
6
47