Filter
Top Products
7
3. With the help of a second person, tip the treadmill onto
the Base (not shown), with the Left and Right Uprights
(9, 10) in a vertical position.
Open part bag B. Hold the Console Crossbar (88) be-
tween the handrails on the Left and Right Uprights (9,
10). Make sure that the square hole in the Crossbar is on
top as shown. Attach the Crossbar with two Crossbar
Bolts (56). Firmly tighten the Crossbar Bolts.
9
10
56
56
Square
Hole
88
3
2. Identify the Right Upright (10), which has the Wire
Harness (17) inside of it. Orient the Right Upright as
s
hown. Cut the band securing the lower end of the Wire
Harness.
Have a second person hold the Right Upright (10) near the
Base (82). Connect the Wire Harness (17) to the wire har-
ness extending from the Base.
Make sure to connect the
connectors properly (see drawing 2a). The connec-
tors should slide together easily and snap into place.
IF THE CONNECTORS ARE NOT CONNECTED PROP-
ERLY, THE CONSOLE MAY BE DAMAGED WHEN THE
POWER IS TURNED ON.
See drawing 2b. Make sure
that there are two U-Nuts (101) in the lower end of the
Right Upright. Carefully wrap the wires around the con-
nectors. Insert the connectors and the excess Wire
Harness into the Base as shown, and then hold the Right
Upright against the Base.
Be careful not to pinch the
wires.
Insert two 3” Bolts (47), with two Washers (29) and two Star
Washers (81), into the Base (82) and loosely thread the
Bolts into the lower end of the Right Upright (10).
Attach a Front Wheel (95) to the Base (82) with a Wheel
Bolt (86). Do not overtighten the Bolt; the Wheel must
be able to turn freely.
With the help of a second person, tip the treadmill onto its
right side. Attach the Left Upright (9) and the other Wheel
(not shown) as described above. Note: There are no wires
in the Left Upright.
10
86
95
17
2
82
81
81
47
47
29
9
17
2a
2b
29
101
101