Filter
Top Products
15. Make sure that all parts are properly tightened before you use the treadmill. Keep the included hex keys
in a secure place. The hex key is used to adjust the walking belt (see page 20). To protect the floor or carpet,
place a mat under the treadmill.
13. Attach the Latch Housing (48) to the Left
Upright (53) with two 18mm Screws (58); start
both Screws before tightening either of
them.
Remove the knob from the pin. Make sure that
the collar and the spring are on the pin. Insert
the pin into the Latch Housing (48), and tighten
the knob back onto the pin.
58
48
53
13
14.
Raise the treadmill to the storage position (see
HOW TO FOLD THE TREADMILL FOR STOR-
AGE on page 17). Attach an Incline Leg (95) to
each side of the Frame (51) with an M8 x 52mm
Bolt (82), two M8 Flat Washers (72), and an M8
Nut (46) as shown.
Note: do not overtighten
the Nuts. The Incline Leg should be able to
rotate easily.
Adjust the Incline Legs (95) to the desired in-
cline (see page 16).
95
72
82
46
72
72
46
95
82
72
14
12. See the lower drawing. Position the Uprights
(53, 54) so that the treadmill Frame (51) is cen-
t
ered between the Uprights.
F
irmly tighten the two M10 x 110mm Bolts (1)
and the four M10 x 58mm Bolts (2). Be careful
not to overtighten the M10 x 110mm Bolts.
With the help of a second person, raise the
Uprights (53, 54) to a vertical position.
12
2
51
1
53
51
54
Top View
1
1
51
Knob
Spring
Pin
Collar