Filter
Top Products
7
2. Have a second person hold the Base (52) in the
position shown.
I
dentify the Left Upright (53) (the Right Upright
[54] has a large hole near the lower end).
Hold the Left Upright (53) so that the two indi-
cated small holes are on top. Attach the Left
Upright to the Base (52) with two M10 x 58mm
Bolts (2). Do not tighten the Bolts yet.
Attach the Right Upright (54) to the Base (52) in
the same way.
2
52
53
2
2
54
L
arge
Hole
Small Holes
3. Slide the two Wheel Housings (45) onto the Base
(52). Attach each Wheel Housing with two M6 x
58mm Bolts (13), two M6 Flat Washers (32), and
two M6 Nuts (43).
3
52
13
32
32
45
43
13
32
32
45
43
4. Remove the bolts (not shown) from the indicated
holes in the Hood (65) (only one side is shown).
Remove the cardboard packaging and discard
the bolts.
Position the Base (52) as close to the front of
the treadmill as possible.
See the inset drawing. Locate the wire tie in
the Right Upright (54). Tie the wire tie securely
to the connector on the end of the Wire Harness
(39). Next, pull the opposite end of the wire tie
out of the upper end of the Right Upright, until
the Wire Harness is routed completely through
the Right Upright. Secure the Wire Harness to
the upper end of the Right Upright so that it will
not fall inside.
52
4
39
54
65
54
39
Wire Tie
Wire Tie
Hole